GRAPHTEC FC9000 Series User Manual page 148

12
Press the [3] key (DURING DETECTION).
The following message is displayed.
13
Press the POSITION (
14
[ENTER] key (SET).
displayed.
15
Press the POSITION (
the data.
) key to move it to the
) keys to set the original distance on
6-6
Supplement
If the MARK SCAN MODE screen does not
appear, press the [2] key (ARMS) in the MENU
screen.
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
Supplement
Repeat steps 13 to 14 when the message
prompting to move to the next registration
mark is displayed.
Number of times to repeat steps 13 to 14 differs
registration mark positions. Follow the message
that is displayed.
It will return to default screen without scanning
the settings when you press the [ESC] key
(CANCEL).
Supplement
Measured distance is displayed in the top
line in the DISTANCE input screen. Input
value (initially same as measured value) is
displayed under that.
If the input value is not changed, it will
assume that there is no difference between
measured distance and the distance in the
data.
Press the [SLOW] key to select the setting
digits.