GRAPHTEC FC9000 Series User Manual page 40

3
Position the media and the push rollers to correspond with
the width of the media.
When the FC9000-75
The push rollers push down on either side of the media. Use
the grit roller position guide to make sure the push rollers are
set on top of the grit rollers.
Push roller
Media
When the FC9000-100/140/160
Use the 3 or 4 push rollers to push down the sides and
center of the media.
Use the grit roller position guide and make sure the push
rollers are on top of the grit rollers.
Push roller
Grit roller
(The push roller is on top of the grit roller.)
(The center push roller is not on top of the grit roller.)
Grit roller
Grit roller position guide
Push roller
Media sensor
Grit roller position guide
Push roller
Media sensor
Supplement
Supplement
(The push roller is on top of the grit roller.)
(The center push roller is near the edge.)
2-14
The media must be at least 125 mm in length.
The media must always be positioned over
the media sensor. (For the location of media
sensor, see "Nomenclature".)
See "Aligning the Push Rollers" for information
about the position of the push rollers.
See "Aligning the Push Rollers" for information
about push roller hold-down force.
The media must always be positioned over
the media sensor.
See "Aligning the Push Rollers" for information
about the position of the push rollers.
See "Aligning the Push Rollers" for information
about push roller hold-down force.