Connecting The Computer; Networking Connectivity Setup - GCC Technologies T500 User Manual

4.2. Connecting the Computer

The LaserPro T500 can communicate with a computer through a USB Port or LAN Port
connection interface. Regardless of the connection method chosen, you will need to connect the
respective connection cable from the LaserPro T500 to your computer.
USB Connectivity: Connect the included USB Port Cable to the USB Port on the right side of the
LaserPro T500.
Ethernet Connectivity:
right-hand side of the laser system. Follow below instruction for Ethernet connectivity setup.
NOTE
1.
Never leave laser system unattended during laser cutting, engraving, and marking process,
even with Ethernet or Wi-Fi connection setup, this requirement cannot be avoided. Exposure
to the laser beam may cause ignition flame to combustible materials.
2. DO NOT connect USB cable to laser machine when going to use Ethernet cable as data
transmission.
3. If you have purchased additional Optional Accessories for the LaserPro T500, please refer to
chapter VII for instructions on how to properly setup your optional accessories. These should
be setup prior to working with your LaserPro T500.

4.2.1 Networking Connectivity Setup

GCC laser engraver is built-in with LAN port to enable multiple laser engravers to be operated by one
PC and multiple PCs to share a single unit of laser engraver. Follow the setup instructions below
using GCC T500 as illustration.
Step 1. Connect LAN cable to the LAN port of GCC laser engravers and turn on machine
Step 2. Navigate the control panel through <F4> Function <Machine Setting> <LAN
Setup Wizard> IP Address.
Connect the Ethernet Cable in accessory to the Ethernet port on the
51 232002080G(09)