GCC Technologies T500 User Manual page 29

5) Plug the air compressor's power cord into the power cord socket on T500 laser cutting system
then you can control air assist via GCC LaserPro driver color pen setting.
NOTE
The voltage provided from power outlet on laser machine depends on the voltage that is
supplied to the machine. The output voltage will be 220V for the air compressor power socket
since a 220V power is supplied to power up the laser machine.
6) Take the unattached end of the ¼" air tubing (other end already connected to air compressor)
and connect it to the air tube connector of the air assist valve on the rear side ofT500 machine.
Make sure press down the air tube fastener when inserting the ¼" air tubing to form a tight,
secure attachment as indicated in the diagram below.
Air Flow Regulator:
Turn Clockwise
to increase
airflow
Turn Counter-
Clockwise to
decrease
airflow
7) Congratulations, you have finished setting up the air compressor.
8) Refer to PEN Page of T500 print driver in Chapter 5 for air assist control through print driver.
29
Air Compressor
Power Socket
Air Tube
Fastener
Air Tube
Connector
232002080G(09)