Chapter Ix - Basic Troubleshooting - GCC Technologies T500 User Manual

Table of Contents

Advertisement

Chapter IX - Basic Troubleshooting

Quality Problems
Check if the focal Lens is installed correctly or if focal Lens is not fixed properly.
Check if it is caused by the debris or dust build up in the bearing tracks of x rail.
Check if it is caused from the damaged or dirty focal lens and mirror 4 in the laser carriage which
can not deliver the laser beam effectively.
Non-operational Problems
Laser beam does not generate
1)
If the red alignment beam is not revealed, the laser beam is misalignment. Adjust reflection
mirrors for exact focus.
2)
If the red alignment beam is revealed, please check the driver power. The laser power may be
too low to be detected. Please increase the percentage setting of the Laser Power from the
software driver or the control panel.
3)
Please check if the laser power connector is loose.
4)
For safety purposes, the laser beam will not be generated when the top or front door is opened.
5)
Check water level or temperature of water cooler for T500 200W only. If over-heated, laser
beam will shut down automatically.
NOTE
Unplug the machine before examining the mirrors, lens, motion system or any other
part of the laser system.
190
232002080G(09)

Advertisement

Table of Contents
loading

Table of Contents