GCC Technologies T500 User Manual page 94

SmartCenter Page
Under SmartCENTER mode the job will begin after the system positions the carriage to the center
position between two points or four points indicated by the user. The SmartCENTER mode has to
be enabled through the driver
Enter SmartCENTER page by pressing the F3 button. You will be prompted to indicate and store
the position points. The positions can be indicated by moving the carriage by hand and pressing
enter to save the positions indicated by the red pointer. After all points are set, the carriage will
move to the center of the stored positions and the job will begin.
Relevant Buttons
F1 (Back)
F2 (Reset)
F4 (Save)
 /  Directional
 /  Directional
Start / Stop
Auto Focus
▲ / ▼ Manual Focus Buttons Manually adjust the height of the work table (Z-
Carriage / Work Table Adjustment Page
Back to previous page
Reset all saved positions
Save current lens carriage position
Manually adjust the Y-axis position of the laser
carriage
Manually adjust the X-axis position of the laser
carriage
Back to Main Work Page
Initiate the auto focus function
axis)
94
☼ navigating to this page:
Main Work Page
Press F3
SmartCenter Page
Function
232002080G(09)