GCC Technologies T500 User Manual page 90

Start / Stop – Allows you to start or stop engraving jobs, once those jobs
have been successfully loaded onto the system.
Delete - Provides quick access to delete the current job.
Pause – Pauses the current engraving process. Press again to resume the
current process.
Cutting Mode – Cutting mode key would access to the three options of cutting quality and speed
combination
LASER
The Laser hot key can easily switch the laser status between on and off . When the laser is off,
the laser carriage would start to work without laser firing after pressing START/STOP key to
better positioning the laser firing path. Once the position of laser firing is confirmed to be correct,
then you can press the LASER key again to enable the laser, and start to laser engraving or
cutting on materials.
Recall– The RECALL key makes the lens carriage applies the saved position as origin.
90 232002080G(09)