GCC Technologies T500 User Manual page 62

Troubleshooting
While users configure the Ethernet setting precisely with DHCP = OFF (assign the machine a
static IP) referring to the manual, sometimes the communication might still not be able to work, at
this time you can refer to below actions to have a basic troubleshooting with IT technician.
1.
Verify the IP addresses you are using to see if they are valid.
Open command line mode in your windows system (Press Windows key + R, the "Run"
i.
window will appear, type "CMD" in the blank bar then press "OK" to open command line
mode)
Command line mode window
62 232002080G(09)