GCC Technologies T500 User Manual page 150

border, you will first need to Invert your design from the Option Page, then check Use Border and specify a
value for the thickness of the border you would like to add to your design.
This mode is useful for engraving rubber stamps, as it allows you to create the outline around your stamp
image.
NOTE
If you wish to use the Border and Cluster function simultaneously, then the Border
Thickness value must be less than the Distance value specified in the Cluster setting.
Vector Function (Advance Page)

Normal: This selection will not apply any special advanced vector function to your job. This is the
default Vector Function setting.

All Raster Output: This selection will instruct the print driver to process your entire image as a raster
engraving. Any vector lines within the image will be treated as raster data and outputted as a raster
engraving, similar to a dot-matrix printer.

Vector Sorting: When performing a vector cutting job in which your image has one vector cut area
enclosed within another vector cut area, select the Vector Sorting mode. This mode will automatically
instruct the print driver to process the inside vector image and moving outwards. If you try to process a
vector image that has multiple layers without using this mode, what may occur is the laser engraver
may process the outer vector cutting first, and any inner vector cutting will not be possible as your
centerpiece material may have dropped to the cutting table. This setting will always automatically direct
the laser to cut from the inner most vector shape and move outwards.

Inside out Cutting: This setting will always automatically direct the laser to cut from the inner most
vector shape and move outwards.
[DEFAULT SETTING: Normal]
150 232002080G(09)