Safety Notice For Class 4 Machine - GCC Technologies T500 User Manual

NOTE
Each LaserPro laser machine is shipped with a single pair of safety goggles. If additional
safety goggles are required, please contact GCC directly or an authorized GCC distributor. If
you wish to purchase one on your own, please make sure the safety goggles meet these
requirements:
NOTE
Each LaserPro laser machine is shipped with a single pair of safety goggles. If additional
safety goggles are required, please contact GCC directly or an authorized GCC distributor. If
you wish to purchase one on your own, please make sure the safety goggles meet these
requirements:

Connect the machine to a properly grounded power outlet. Ensure the voltage of the power
source is identical to the voltage of the machine.

Do not open the laser access panel when the machine is plugged in.

Do not attempt to modify or disassemble the laser module.

Do not attempt to remove or modify any component of the machine's laser interlock safety
system.

Ensure the immediate work area of the machine is well-ventilated. Odors, vapors, and dust
are byproducts generated during the laser engraving and cutting process.
system, vacuum cutting box, and honeycomb table are recommended. Please contact GCC
or your local GCC distributor for more information.

Do not laser heat-sensitive surfaces or materials that may generate toxic fumes, such as
PVC and Teflon.

Regularly clean and maintain your machine according to our cleaning and maintenance
instructions. Doing so will ensure your machine will operate effectively and safely over a
long period of time.

1.5.2 Safety Notice for Class 4 Machine

When the optional Pass-Through door module is installed, the laser system becomes a Class 4
machine with front and rear doors open, machine operators must wear goggles and follow the
safety instructions to operate the machine.
9000-11000nm OD5+
Visible Light Transmission: 92.9%
190 - 534 nm OD5+
910-1070 nm OD6+
Visible Light Transmission: 23.5%
13
An exhaust
232002080G(09)