Connecting The Computer; Networking Connectivity Setup - GCC Technologies LaserPro X500 III-80Y User Manual

4.1.10 Connecting the Computer

The LaserPro X500 Series can communicate with a computer through a USB Port or LAN
Port connection interface. Regardless of the connection method chosen, you will need to
connect the respective connection cable from the LaserPro X500 Series to your computer.
USB Connectivity:
the LaserPro X500 SERIES.
Ethernet Connectivity:
the right-hand side of the laser system. Follow below instruction for Ethernet connectivity
setup.
NOTE
If you have purchased additional Optional Accessories for the LaserPro X500 SERIES,
please refer to chapter VII for instructions on how to properly setup your optional
accessories. These should be setup prior to working with your LaserPro X500 SERIES.

4.1.10.1 Networking Connectivity Setup

GCC laser engraver is built-in with LAN port to enable multiple laser engravers to be operated by one
PC and multiple PCs to share a single unit of laser engraver. Follow the setup instructions below
using GCC Spirit GLS machine as illustration.
Step 1. Connect LAN cable to the LAN port of GCC laser engravers and turn on machine
Step 2. Navigate the control panel through <F4> Function
Setup Wizard>
Step 3. Go to Windows <Control Panel>
click on Spirit series printer to check printer properties.
Step 4. Go to <Ports> tab of Spirit series printer properties, and select <Add Port>, and follow
the instruction to enter the TCP/IP information received from laser machine control panel in
step 2.
Connect the included USB Port Cable to the USB Port on the right side of
Connect the Ethernet Cable in accessory to the Ethernet port on
IP Address.
<Machine Setting>
<Hardware and Sound>
29
<LAN
<Printer>, and right
232001260G(10)