GCC Technologies T500 User Manual page 120

Advanced Option- SmartGUARD Page
After optional SmartGUARD hardware installation, please enter the function menu on the control
panel to enable the SmartGUARD fire alarm. Note SmartGUARD fire alarm system is not a fire
extinguisher, but a fire detecting and alarm system.
SmartGUARD Enable/ Disable:
Press directional key (Left or Right) to enable the SmartGUARD device or disable it.
Sensitivity：
Press directional key (left or right) to set the sensitivity of SmartGUARD. There are five sensitivity
settings (1, 3, 5, 7, 9 seconds) that can be selected. Sensitivity is defined by the delay time from
when a fire is detected until the fire alarm alerts user, and automatically shuts down the laser
system. For example, if the sensor delay switch is set to the 3-second position, the SmartGUARD
will start an alarm and automatically shut-down the laser system after detecting a fire for 3 seconds.
Stow Carriage：
This function will decide if the lens carriage stay in the last position (set to <NO>) or move to the
opposite direction (up or down) when a fire is initiated. The default is <YES>, the lens carriage will
move to opposite direction when a fire occurred.
Relevant Buttons
F1 (Back)
 /  Directional
 /  Directional
Enter
Start / Stop
SmartGUARD Page
Back to previous page
Scroll through the menu selections
Adjust the value for that selection
Perform the selection
Back to Main Work Page
120
Navigating to this page:
Main Work Page
Functions Page
Advanced Option Page
SmartGUARD Page
Function
232002080G(09)
press F4
Select<Advanced
Options>from menu
Select<SmartGUARD>
from the menu