Machine Setup; Powering Up The Machine; Connecting The Computer; Networking Connectivity Setup - GCC Technologies LaserPro Spirit Series User Manual

4.1 Machine Setup

4.1.1 Powering Up the Machine

Make sure both the LaserPro Spirit Series and the computer are turned off before
connecting either to a power source.
1) Connect the male end of the power cord to a quality surge protector and then connect the
surge protector to a properly grounded outlet.
2) Do the same for the computer system.
3) Connect the air compressor and external air extraction system to the laser machine before
powering up. The connection and setup of air compressor and air extraction system refer to
Chapter 7 for details.
4) Connect the female end of the power cord into the machine's power cable inlet located on the
right side of machine.
NOTE
• The LaserPro Spirit Series has been designed to automatically switch from 100-240 VAC.
• Make sure to supply 220 VAC of electricity to the LaserPro Spirit Series with laser 80Watt
and above.

4.1.2 Connecting the Computer

The LaserPro Spirit Series can communicate with a computer through a USB Port or LAN Port
connection interface. Regardless of the connection method chosen, you will need to connect
the respective connection cable from the LaserPro Spirit Series to your computer.
USB Connectivity:
of the laser system.
Ethernet Connectivity:
right-hand side of the laser system. Follow below instruction for Ethernet connectivity setup.
NOTE
If you have purchased additional Optional Accessories for the LaserPro Spirit Series,
please refer to chapter VII for instructions on how to properly setup your optional
accessories. These should be setup prior to working with your LaserPro Spirit Series.

4.1.2.1 Networking Connectivity Setup

GCC laser engraver is built-in with LAN port to enable multiple laser engravers to be operated by one
PC and multiple PCs to share a single unit of laser engraver. Follow the setup instructions below.
Step 1. Connect LAN cable to the LAN port of GCC laser engravers and turn on machine
Step 2. Navigate the control panel through <F4> Function
C A UTION
Connect the included USB Cable to the USB Port on the right-hand side
Connect the Ethernet Cable in accessory to the Ethernet port on the
48
<Machine Setting> <LAN Setup
232001290G(12)