5.2 The LaserPro T500 Print Driver
With the LaserPro T500 print driver successfully installed, you will need to adjust the printer and page size
default settings before you can begin editing and completing jobs. By doing so, you will be setting the work
area in your graphics software to match the LaserPro T500's worktable area.
NOTE
Please make sure T500 is set to the default printer before proceeding to the page and layout
setup.
Ensure that the LaserPro T500 has been selected as the DEFAULT PRINTER. You
can do so by going into your Windows Control Panel Printers and Faxes.
If LaserPro T500 is not selected as DEFAULT PRINTER, you may set it up through the graphics software
as well. The following example takes Corel Draw to demonstrate how to set up LaserPro T500 as the
Printer.
From the primary menu, click FILE PRINT SETUP.
1)
From the navigation bar Name, click T500 OK
2)
5.2.1 Ethernet Connectivity Setup
GCC laser engraver is built-in with LAN port to transmit data from PC to laser engraver with ease and
higher speed, also enable multiple laser engravers to be operated by one PC and multiple PCs to share a
single unit of laser engraver. Hereunder illustration will use Spirit series as an example.
Step 1. Connect LAN cable to the LAN port of GCC laser engravers and turn on machine
Step 2. Navigate the control panel through <F4> Function <Machine Setting> <LAN Setup
124
232002080G(09)