GCC Technologies T500 User Manual page 149

TIP
It is highly recommended you enable the red dot laser pointer when setting / adjusting
the Position Modes, as this will ease your job positioning with more accuracy.
Image Output Direction (Advance Page)
These selections allow you to control the direction in which the system processes an engraved image.

Top To Bottom: Selecting this will force the system to process the current task by moving the laser
carriage from the top to the bottom of the image (rear end to front end of the work table).

Bottom To Top: Selecting this will force the system to process the current task by moving the laser
carriage from the bottom to the top of the image (front end to rear end of the work table)
(Normally, the LaserPro T500 engraves from left to right, top to bottom. Selecting Bottom Up will force the
machine to start from the bottom and work its way to the rear of the working table.
TIP
In situations where the material you will be working with may produce a lot of dust
byproducts and you are utilizing the optional Fume Extraction system, it is
recommended you select the Bottom To Top image output direction option. This will
minimize the amount of dust byproducts lodged in the engraved sections as the Fume
Extraction system is vented from the rear of the machine, the same direction as the
image is processed.
Border (Advance Page)
In cases where you are working with a negative image (negative outline areas of your image are engraved,
rather than the positive areas), you may wish to include a border around your image. To properly add a
[DEFAULT SETTING: Top to Bottom]
[DEFAULT SETTING: Unselected]
149 232002080G(09)