Install The Irrigation Pump Gear Motor; Replace The Irrigation Pump Bezel - Integra Cusa Excel Service Manual

Table 11-8.
Irrigation pump control card
connections
CUSA EXcel Ultrasonic Surgical Aspirator System Service Manual

Install the Irrigation Pump Gear Motor

When you have put the coupling on the new gear motor drive shaft, making
1.
sure that the coupling is in the same position on the new drive shaft as it was
on the old drive shaft, tighten the drive set screw.
Position the gear motor on the bracket.
2.
Replace the four screws and four lock washers (10 - 32 Phillips) that attach the
3.
gear motor to the bracket.
Put the gear motor and its bracket into the frame, then push them into position.
4.
Replace the four screws and four lock washers (M5 Phillips) that attach the
5.
gear motor bracket to the console frame.
Remove the hex nut (M4) that secures the control card and bracket to the
6.
frame.
Pull the control card bracket far enough from the frame to reconnect the
7.
irrigation gear motor:
Wire or connector Terminal
6-pin J1
brown A
red B
orange C
Reconnect the gear motor ground wire to the frame.
8.
Push the control card bracket back in the frame and secure it with four hex
9.
nuts, four washers, and four lock washers (M4).
Position the panel on the console frame. Ensure that the tang on the irrigation
10.
pump shaft aligns with the motor shaft coupling.
Replace the four screws (M5 Phillips) and four lock washers (M5) that attach
11.
the panel to the frame.

Replace the Irrigation Pump Bezel

Four ball-end retainers hold the irrigation pump bezel in place. Align the
1.
retainers with their holes in the console, then push the bezel into place.
Close the irrigation pump latch by rotating the latch lever clockwise until it
2.
reaches the 3 o'clock position.
Plug the power cord connector into the wall receptacle.
3.
Turn on the AC Main Switch, located on the rear panel.
4.
Irrigation Pump Head and Gear Motor
11-45