Install The Irrigation Pump Head - Integra Cusa Excel Service Manual

Irrigation Pump Head and Gear Motor
Figure 11-30.
Removing the irrigation pump head
Important
Do not overtighten the screws. If
the screws are too tight, they can
crack plastic parts in the pump
head.
11-42
Remove two screws (8 - 32 buttonhead) from the front of the irrigation pump.
1.
These screws fasten the pump head to a flat panel.
Pull the pump forward to remove it from the panel.
2.

Install the Irrigation Pump Head

Refer to Figure 11-30.
Open the irrigation pump latch completely.
1.
View the end of the gear motor coupling, noticing the position of the slot in
2.
the end of the coupling. Position the shaft tang in the pump head to match the
position of the slot in the gear motor coupling.
Insert the shaft tang into the slot on the gear motor coupling.
3.
Position the pump head on the panel, making sure that the head is flat against
4.
it.
Insert two screws (8 - 32 buttonhead), through the front of the pump head.
5.
Set the screws with a 3/32 in. Hex key or Allen wrench.
6.
Rotate the pump shaft by hand to ensure that the shaft tang has seated properly
7.
in the gear motor coupling.
CUSA EXcel Ultrasonic Surgical Aspirator System Service Manual
Irrigation pump head