Additional-Stage Cooling Parameter Window - ABB i-bus FCC/S 1 1 Series Product Manual

®
ABB i-bus KNX
Parameters
7.5.1.9

Additional-stage cooling parameter window

This window is only visible if the Deactivated option has not been selected in the Additional-stage
cooling parameter in the Application parameters parameter window.
This window is deactivated in the actuator mode and is not visible.
The additional-stage cooling of the temperature controller is parameterized in this window. The set-
tings for the control type, limitation of the control range, the behavior on sending the control value
and the limit temperature are made.
Fig. 40: Additional-stage cooling
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 205