Basic-Stage Heating Parameter Window - ABB i-bus FCC/S 1 1 Series Product Manual

®
ABB i-bus KNX
Parameters
7.5.1.6

Basic-stage heating parameter window

This window is only visible if the Deactivated option has not been selected in the Basic-stage
heating parameter in the Application parameters parameter window.
This window is deactivated in the actuator mode and is not visible.
The basic-stage heating of the temperature controller is parameterized in this window. The settings
for the control type, limitation of the control range, the behavior on sending the control value and
the limit temperature are made.
Fig. 37: Basic-stage heating
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 167