Operating And Display Elements - ABB i-bus FCC/S 1 1 Series Product Manual

®
ABB i-bus KNX
Product Overview
3.8.3

Operating and display elements

Button/LED
Table 14: Operating and display elements – general
Manual operation
Button/LED
Valve output changeover
Open valve output
Close valve output
Open/close relay output
Description/Function
Assignment of the physical ad-
dress.
Description/Function
Switches between valve A and
valve B
If a valve output has been disabled
in the parameters, it is not possible
to select the valve.
Maximum valve control value
(100 %) set.
Reset both outputs:
Button must be pressed for at least
5 seconds.
Minimum valve control value (0 %)
is set.
Relay is switched.
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 51
LED indicator
On: Device is in programming
mode.
LED indicator
On: Indicates the selected valve
Flashing: Error (overload/short cir-
cuit) on the output concerned
On: Valve control value at 100%
Flashing: Indicates a fault, e.g.
overload/short circuit
On: Valve control value at 0 %
Flashing: Indicates a fault, e.g.
overload/short circuit
Both LEDs on: Valve control value
between 1 % and 99 %
Both LEDs off: Fault
On: Contact closed
Off: Contact open