ABB i-bus FCC/S 1 1 Series Product Manual page 315

®
ABB i-bus KNX
Parameters
—
7.13.1.5.4 Dependent Parameter
Reaction on event X
The following apply to the Reaction on event 0 and Reaction on event 1 parameters.
Options:
The standard value for Reaction on event 1 is On. The standard value for Reaction on event 0 is
Off.
This determines how the group object reacts. If the Distinction between long and short operation
parameter is set to Yes, the reaction occurs with a short or long operation. If it is set to No, it oc-
curs with each edge change.
If it is set to End cyclic transmission, it is important to note that this is only effective if the Send
status value parameter is set to On change and cyclically.
No edge evaluation
On
Off
Toggle
End cyclic transmission
Note
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 315