ABB i-bus FCC/S 1 1 Series Product Manual page 235

®
ABB i-bus KNX
Parameters
—
7.7.1.1.1.4 Dependent Parameter
Relay output / Relay output for forced operation ON / Relay output for forced operation OFF
This parameter does not apply to FCC/S 1.4.1.1.
Options:
This parameter is used to specify the relay state that is to apply with forced operation active (for 2-
bit in the related state, ON or OFF).
• Unchanged: The relay remains in its current position if forced operation is activated.
• On: The relay is switched on if forced operation is activated.
• Off: The relay is switched off if forced operation is activated.
After forced operation has been disabled, the control values specified by the controller apply
again directly.
The fan changes to the automatic mode on the deactivation of forced operation.
During forced operation the device continues to receive group objects via the bus, however it
does not react to them as long as they do not have a higher priority than forced operation. The
device therefore continues to work normally after forced operation is disabled.
7.7.1.1.2 Selection of actuator device
The following parameters are visible if the Actuator device option has been selected in the Device
function parameter.
Unchanged
On
Off
Note
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 235