ABB i-bus FCC/S 1 1 Series Product Manual page 225

®
ABB i-bus KNX
Parameters
—
7.6.4.1.3 Dependent Parameter
Standby cooling setpoint
This parameter is only visible if the device has been parameterized for cooling and the Deactivated
option has not been selected for the Basic-stage cooling parameter in the Application parameters
parameter window, and the Setpoint specification and adjustment parameter has been parameter-
ized with the Absolute option.
Options:
This parameter is used to set the temperature that is to apply in the Standby operating mode in the
type of operation cooling.
The temperature stated here must be higher than the temperature selected in the Comfort
cooling setpoint or Setpoint for Comfort heating and cooling parameter. A temperature that is at
least 2 °C higher is recommended.
The controller does not change the type of operation to reach this temperature, instead it ensures
this temperature is not exceeded on an increase in the actual temperature.
—
7.6.4.1.4 Dependent Parameter
Economy cooling setpoint
This parameter is only visible if the device has been parameterized for cooling and the Deactivated
option has not been selected for the Basic-stage cooling parameter in the Application parameters
parameter window, and the Setpoint specification and adjustment parameter has been parameter-
ized with the Absolute option.
Options:
This parameter is used to set the temperature that is to apply in the Economy operating mode in
the type of operation cooling.
The temperature stated here must be higher than the temperature selected in the Standby
cooling setpoint parameter. A temperature that is at least 2 °C higher is recommended.
The controller does not change the type of operation to reach this temperature, instead it ensures
this temperature is not exceeded on an increase in the actual temperature.
10...19...40
Note
10...17...40
Note
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 225