ABB i-bus FCC/S 1 1 Series Product Manual page 234

®
ABB i-bus KNX
Parameters
—
7.7.1.1.1.2 Dependent Parameter
Fan output / Fan output for forced operation ON / Fan output for forced operation OFF
This parameter only applies to:
• FCC/S 1.1.1.1
• FCC/S 1.1.2.1
• FCC/S 1.2.1.1
• FCC/S 1.2.2.1
• FCC/S 1.4.1.1
Options:
This parameter is used to specify the fan speed that is to apply with forced operation active (for 2-
bit in the related state, ON or OFF).
• Unchanged: The same fan speed as before the activation of the forced operation applies.
• Applies control value: The speed is dependent on the valve control value. The automatic mode
is active.
• 1: The fan runs at speed 1.
• 2: The fan runs at speed 2.
• 3: The fan runs at speed 3.
—
7.7.1.1.1.3 Dependent Parameter
Fan output / Fan output for forced operation ON / Fan output for forced operation OFF
This parameter only applies to:
• FCC/S 1.3.1.1
• FCC/S 1.3.1.1
• FCC/S 1.5.1.1
• FCC/S 1.5.2.1
Options:
This parameter is used to specify the fan speed that is to apply with forced operation active (for 2-
bit in the related state, ON or OFF).
• Unchanged: The same fan speed as before the activation of the forced operation applies.
• Applies control value: The speed is dependent on the valve control value. The automatic mode
is active.
• 33 %: The fan runs at speed 33 %.
• 66 %: The fan runs at speed 66 %.
• 100 %: The fan runs at speed 100 %.
Unchanged
Applies control value
1
2
3
Unchanged
Applies control value
33 %
66 %
100 %
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 234