Additional-Stage Heating Parameter Window - ABB i-bus FCC/S 1 1 Series Product Manual

®
ABB i-bus KNX
Parameters
7.5.1.7

Additional-stage heating parameter window

This window is only visible if the Deactivated option has not been selected in the Additional-stage
heating parameter in the Application parameters parameter window.
This window is deactivated in the actuator mode and is not visible.
The additional-stage heating of the temperature controller is parameterized in this window. The
settings for the control type, limitation of the control range, the behavior on sending the control
value and the limit temperature are made.
The additional stage is used as a boost for the basic stage. If there are large deviations between
the actual and setpoint temperature, the additional stage is activated to accelerate reaching the
setpoint temperature.
Fig. 38: Additional-stage heating
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 180