ABB i-bus FCC/S 1 1 Series Product Manual page 309

®
ABB i-bus KNX
Parameters
7.13.1.5.1.2 Example: Maximum dead time of the input signal for a detected edge
Fig. 55: Maximum dead time of the input signal for a detected edge
After detection of an edge on the input, further edges are ignored for the maximum dead time T
—
7.13.1.5.2 Dependent Parameter
Distinction between long and short operation
Options:
This parameter determines whether the input differentiates between short and long operation.
• Yes: After opening/closing the contact, an initial evaluation determines whether the operation
was long or short before triggering any reaction.
The following diagram shows the function in detail:
Fig. 56: Distinguishing between a short/long operation
T
L
7.13.1.5.2.1 No
If the parameter Distinction between long and short operation is set to No, the following parame-
ters appear:
No
Yes
Note
is the time before a long operation is detected.
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 309
.
D