®
ABB i-bus
KNX
Parameters
7.13
Input x parameter window
The setting options for inputs a...d are explained below using input a as an example.
The setting options are identical for all inputs.
When using input a to connect an analog room control unit, parametrize the input on the Setpoint
adjustment page.
Fig. 54: Parameter input x
7.13.1
Input
Options:
This parameter sets the operating mode for the input. Dependent parameters appear according to
the selected option.
Note
Note
Deactivated
Window contact
Dew point sensor
Fill level sensor
Temperature sensor
Binary signal input
Analog room control unit
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 299