ABB i-bus FCC/S 1 1 Series Product Manual page 118

®
ABB i-bus KNX
Parameters
—
7.4.1.1.1.2.7.1 Dependent Parameter
Automatic reset of manual relay overdrive to controller operation after
This parameter is only visible if the Yes option has been selected in the Switch relay output
independently of fan speed (including when fan = 0) parameter.
Options:
This parameter defines when switching of the relay outside the control is to be reset and controller
operation activated again.
For the time stated here the relay output can be overridden via the group object. Only after this
time has elapsed is the control value specified by the controller applied again for the relay.
A change in the operating mode from heating to cooling will always reset the relay manual override
to controller operation.
00:00:30...00:05:00...18:12:15
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 118