Adding Or Replacing Components; Setting The Profisafe Address - WAGO -I/O-SYSTEM 750 Series Manual

WAGO-I/O-SYSTEM 750
753-661/000-003 4FDI 24V PROFIsafe V2 iPar
The date of manufacture (calendar week/year) marks the beginning of the proof
test interval.
The proof test interval is specified in the technical data of the respective
PROFIsafe I/O module.
Pos: 44.4 /Serie 750 (WAGO-I/O-SYSTEM)/Service/PROFIsafe/PROFIsafe Prooftest 75x-066x/000-003 Text Ende der Gebrauchsdauer @ 23\mod_1437393018334_21.docx @ 186498 @ @ 1
At the end of the proof test interval, the usage duration of the PROFIsafe I/O
module is also reached. The PROFIsafe I/O module must then be replaced.
Pos: 45 /Serie 750 (WAGO-I/O-SYSTEM)/In Betrieb nehmen/PROFIsafe in Betrieb nehmen/PROFIsafe Hinzufügen und Austauschen von Komponenten @ 7\mod_1272289792546_21.docx @ 55674 @ 3 @ 1
8.1.2

Adding or Replacing Components

If PROFIsafe I/O modules are added to a fieldbus node (see section "Inserting and
Removing Devices") or replaced (see section "Replacing PROFIsafe I/O
Modules"), the associated safety function should undergo additional testing before
starting up the machine or system.
Pos: 46 /Serie 750 (WAGO-I/O-SYSTEM)/In Betrieb nehmen/PROFIsafe in Betrieb nehmen/PROFIsafe-Adresse einstellen 75x-066x/000-003 @ 6\mod_1265039936312_21.docx @ 49153 @ 233 @ 1
8.2

Setting the PROFIsafe Address

The PROFIsafe address can be set by the coding switch of the I/O module or by
the WAGO parameterization tool.
The PROFIsafe address set on the coding switch of the I/O module has priority
over the PROFIsafe address set by the WAGO parameterization tool.
Only when the address set on the coding switch equals 0 does the setting of the
PROFIsafe address using the WAGO parameterization tool take effect.
Default status address setting
In the default status, the address setting by the coding switch is active.
Manual
Version 1.4.0, valid from HW/SW Version 01/02
Commissioning 71