WAGO -I/O-SYSTEM 750 Series Manual page 123

WAGO-I/O-SYSTEM 750
753-661/000-003 4FDI 24V PROFIsafe V2 iPar
Table 42: PROFIsafe F Parameters
F Parameters
F_Block_ID
F_Par_Version
F_Source_Add
Manual
Version 1.4.0, valid from HW/SW Version 01/02
Default Value Description
0 / 1 The F_Block_ID parameter specifies the
format of the F parameter set. If F_Block_ID
has the value 0, the F_iPar_CRC parameter is
not included in the F parameters and the iPar
server is not used. If F_BLOCK_ID has the
value 1, the F_iPar_CRC parameter is included
in the F parameters and the PROFIsafe I/O
module can use the iPar server.
The PROFIsafe I/O module supports both
formats. To set this parameter, the correct
PROFIsafe I/O module must be selected for
device configuration with the configuration
tool of the safe PLC:
F_Block
_ID
0
1
The F_Par_Version parameter specifies the
V2 mode
PROFIsafe version to be used communication.
The PROFIsafe I/O module supports
PROFIsafe V1 mode and PROFIsafe V2 mode
and use the version specified with this
parameter:
F_Par_Version
V1 mode
V2 mode
The F_Source_Add parameter specifies the
2004
PROFIsafe source address. To prevent
incorrect parameterization, the address of the
configuration tool is automatically assigned
and cannot be changed.
The parameter can accept values from 1 to
65534.
Module designation
<v>T - 101 GSD ohne iPAR</v>
<v>T - 102 GSD mit iPAR</v>
Version
PROFIsafe V1 mode
PROFIsafe V2 mode
Appendix 123