Installation And Removal - WAGO 2789-9080 Product Manual

Installation and Removal

Installation and Removal 6
NOTICE
!
Do not cover the ventilation openings!
Covered ventilation openings can lead to overheating of the product.
• Keep all ventilation openings clear!
The letters shown in parentheses refer to positions in figure "View" in
Note
Mounting positions
The nominal mounting position is (see also figure "View" in
ing forwards, marking legible, bottom ventilation openings (b) facing upwards and down-
wards
Mounting
Install the product by snapping it onto the WAGO Power Supply Pro 2 (see figure "Instal-
lation"):
1. Remove the cap from the communication interface on the WAGO Power Supply Pro
2.
2. Keep the cap in a safe place so that you can cover the communication interface
again when this interface is not required.
3. Remove the mounted marker carrier from the WAGO Power Supply Pro 2.
4. Insert the product with the lower latches into the lower mounting slots of the WAGO
Power Supply Pro 2 [A].
5. Slide the product toward the communication interface [B] until the top latches latch
into the top mounting slots.
6. Verify that the product is snapped on properly.
30 | Version: 1.1.0
Communication Module IO-Link
2789-9080
8 View
[} 10].
8 View
[} 10]): front side fac-
B
A
Figure 7: Mounting