WAGO -I/O-SYSTEM 750 Series Manual page 101

WAGO-I/O-SYSTEM 750
753-661/000-003 4FDI 24V PROFIsafe V2 iPar
Table 38: Diagnostic Messages
Alarm
Invalid
iParameters
Invalid iParam.
from iPar server
Invalid F_CRC1
Invalid
F_Dest_Add
Invalid
F_Source_Add
Manual
Version 1.4.0, valid from HW/SW Version 01/02
Diagnostic
Module Diagnostics
type
Coding 0x0200
LED Group error (E) red,
indication parameterization (H) red, 1 Hz flashing
The individual parameter set for the F I/O
module is inconsistent. Correct the
Solution
parameterization taking into account
dependencies between individual settings.
Diagnostic
Module Diagnostics
type
Coding 0x004B
LED Group error (E) red,
indication parameterization (H) red, 1 Hz flashing
The individual parameter set for the F I/O
module provided by the iPar server are
Solution inconsistent. Make sure that a valid
iParameter set exists on the iPar server.
Check fieldbus transmission if necessary.
Diagnostic
Module Diagnostics
type
Coding 0x0047
LED Group error (E) red
indication PROFIsafe (G) red
The F_CRC1 form from the F parameter
Solution set is invalid. Create a consistent F
parameter set.
Diagnostic
Module Diagnostics
type
Coding 0x0041
LED
Group error (E) red
indication
The PROFIsafe address of the F I/O
Solution module must lie within the range of 1 to
65534. Correct the F parameterization.
Diagnostic
Module Diagnostics
type
Coding 0x0042
LED Group error (E) red
indication PROFIsafe (G) red
The PROFIsafe address of the F host must
Solution lie within the range of 1 to 65534. Correct
the F parameterization.
Diagnostics
Description
101