Nord Drivesystems NORDAC FLEX SK 200E Series User Manual page 185

Pos : 466 /Anleitungen/El ektr oni k/FU und Starter/5. Par ameter/Par ameter auflistung (P000 ...)/P400- P499/Parameter P480...P481 – Ver wendung der Mer ker @ 6\mod_1422968583767_388.doc x @ 201078 @ @ 1
P480 ... P481 Using flags
With the aid of the two flags it is possible to define simple, logical sequences of functions.
To do this, the "triggers" for a function (e.g. a motor PTC overtemperature warning) are defined in
parameter (P481) in arrays [-07] - "Flag 1" or [-08] - "Flag 2"
As well as this, the function which the frequency inverter is to execute when the "trigger" is active
- i.e. the response by the frequency inverter is defined in parameter (P480) in arrays [-09] or [-10].
Example:
In an application, if the temperature of the motor reaches the overtemperature range
("Overtemperature motor PTC") the frequency inverter is to immediately reduce the speed to a
specific speed (e.g. by means of an active fixed frequency). This is to be implemented by
"Deactivation of analog input 1" via which in this example, the actual setpoint is normally set.
This is used to reduce the load on the motor, so that the temperature can stabilise or the drive
unit reduces speed to a defined value before a shut-down due to error is made.
Step
It should be noted that depending on the function which is selected in (P481) the function may
need to be inverted by modification of the standardisation (P482).
Pos : 467 /Allgemein/Allgemeingültig e Module/---------Seitenumbr uc h kompakt --------- @ 13\mod_1476369695906_0.doc x @ 2265495 @ @ 1
BU 0200 en-3118
Description
Determine the trigger
1
Set Flag 1 to the "Motor overtemperature" function
Specify the reaction,
2
Set Flag 1 to the function "Setpoint 1 On/Off
5 Parameter
Function
P481 [-07]  Function "12"
P480 [-09]  Function "19"
185