Nord Drivesystems NORDAC FLEX SK 200E Series User Manual page 167

18 = Curve travel calculator, via the external analogue input (P400 [-03] or P400 [-04]) or via
19 = Servo mode torque, in servo mode ((P300)= "1") the motor torque can be set / limited
25 = Transfer Factor Gearing
26 =
30 = Motor temperature: enables measurement of the motor temperature with a
33 = Setpoint Torque Proc. cntrl.
34 = d-correction F process - (diameter correction, frequency PI / process controller).
35 = d-correction Torque -
36 = d-correction F + Torque - (diameter correction, frequency for PI / process controller and
*) For further details of the PI and process controller, please refer to Section 8.2 "Process
controller".
**) The limits of these values are formed by the parameters >minimum frequency auxiliary
setpoint values< (P410) and the parameter >maximum frequency auxiliary setpoint values<
(P411), whereby the limits defined by (P104) and (P105) cannot be undershot or overshot.
Pos : 422 /Allgemein/Allgemeingültig e Module/---------Seitenumbr uc h kompakt --------- @ 13\mod_1476369695906_0.doc x @ 2265495 @ @ 1
BU 0200 en-3118
the BUS (P546 [-01 .. -03]) the master receives the actual speed from the slave. From its
own speed, the slave speed and the guide speed, the master calculates the actual
setpoint speed, so that neither of the two drives travels faster than the guide speed in the
curve.
using this function. As of firmware version V1.3 this function is also without speed
feedback, however it can be used at a lower quality.
,
variable transfer of a setpoint value. E.g.: Setting of the transformation between the
master and the slave by means of a potentiometer.
...reserved
, for Posicon, see
-
KTY 84 temperature sensor ( Section
of the torques to coupled drive units (e.g.: S-roller drive). This function is also possible
with the use of ISD control.
"Gearing Transfer Factor", is a multiplier to compensate for the
BU0210
4.4 "KTY84-130 connection"
,
"Setpoint torque process controller", for even distribution
(diameter correction, torque).
torque)
5 Parameter
)
167