Setting A Auto Power-Off; Setting Take-Up Unit; Setting Top Blower; Setting The Display Of Media Residual - MIMAKI TS55-1800 Operation Manual

Chapter 3 Setup

Setting a AUTO Power-off

When no operation has been performed for the set time,
the power supply is automatically turned "OFF".
1
Press
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
OFF", and press the
3
Press
press the
• Set Value : none, 10 to 600min
4
Press the
end the setting.

Setting Take-up unit

For the "TAKE-UP UNIT" settings, set the following items:
• Use / do not use sub take-up unit.
• Operation when pressing ON/OFF button of sub take-up unit.
1
Press
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
and press the
3
Press
Unit", and press the
4
Press the
• "Sub Take-up Unit" will be selected.
5
Press
press the
• Set Value : ON / OFF
6
Press , and press the
• "Sub Take-up SW" will be selected.
7
Press
press the
• Set Value : Continuance/ Temporary
Continuance :
Switching ON / OFF the winding operation when
pressing the switch each time. (Take-up unit in
operation does not stop until press again ON /
OFF switch.)
Temporary :
Do the winding operation only while holding
down the switch. (When release the switch,
winding operation is stopped.)
8
Press the
end the setting.
3-14
(MENU) (twice)
to select "AUTO POWER
key.
to select a set value, and
key.
key several times to
(MENU) (twice)
to select "TAKE-UP UNIT",
key.
to select "Sub Take-up
key.
key.
to select a set value, and
key.
key.
to select a set value, and
key.
key several times to

Setting Top Blower

Set the operation of the top blower in print.
Turn the top blower setting "ON", and you can set the
strength for the blower.
1
Press
(MENU)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select "Top blower",
and press the
3
Press to select "ON", and press
the key.
• ON : You can choose the air volume of the
blower.
• OFF: The top blower does not work while printing
process. Proceed to step 6.
4
Press to select "STRENGTH",
and press the
5
Press to select a set value
(AUTO/ STRONG/ WEAK), and press the
key.
• Set value : ON/ OFF
6
Press the
end the setting.

Setting the Display of Media Residual

Whether the screen displays the remaining amount of a
media is set.
When the media
remaining amount The remaining amount of a media is
display is turned to displayed in Remote.
"ON"
When the media
remaining amount The remaining amount of a media is
display is turned to not displayed in the Remote.
"OFF"
• The amount of a media that has been fed by the
printing and jog keys is reflected in the remaining
amount of a media.
• The length of a media (initial value of the
remaining amount) is entered when a roll media is
detected.( P.2-8)
• The setting configured here does not become
effective unless media detection is performed after
the setting has been complete.
1
Press
(MENU)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select "MEDIA
REMAIN", and press the
3
Press to select ON/OFF.
4
Press the
(twice)
key.
key.
key several times to
(twice)
key.
key.