Siemens Synco 700 RMZ785 Basic Documentation page 125

Configuration
Setting values
Display values
Wiring test
126 / 216
Siemens
Building Technologies
8.5.4 Assign input
Main menu > Commissioning > Extra configuration > Aggregates > Modulating outputs >
Modulating output A...H >
Operating line
Input 1...
Input 3
8.5.5 Start condition
 Enable the modulating output via a digital signal.
 The output signal is issued by considering any limitations.
 0 V is issued at the output, or 10 V for inversion, if the start signal is withdrawn.
 Maximum selection.
 The output is always enabled if there is no start condition.
Main menu > Commissioning > Extra configuration > Aggregates > Modulating outputs >
Modulating output A...H >
Operating line
Start condition
8.5.6 Assign texts
Assign text to each modulating output.
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Aggregates > Modulating outputs > Modulating output A...H >
Operating line
Modulating output A ...H
See Section 16.4 "Editable texts RMS705B" for an overview of all editable texts
and on how to reset them.
8.5.7 Function check / wiring test
The current state of the modulating output is displayed on the operator unit.
Main menu > Aggregates > Modulating outputs >
Operating line
Modulating output A ...H
You can directly control the modulating output during the wiring test.
Main menu > Commissioning > Wiring test > Outputs >
Operating line
Modulating output A ...H
Switching and monitoring device RMS705B
Aggregates
Adjustable values / Comment
---, N.X1, sequence controller x.Rot'step'swi y
(analog values only).
Adjustable values / Comment
---, N.X1, N.X2, ... (digital only).
Range
Max. 20 characters
Comment
0...100 %
Comment
----, 0...100 %
Factory setting
Modulating output A ...H
CE1P3124en
01.04.2010