Signal Doubler/Inverter - Siemens Synco 700 RMZ785 Basic Documentation

Purpose
Configuration
Setting values
134 / 216
Siemens
Building Technologies
9.3

Signal doubler/inverter

a
S p lit-In v
A B
Y a Y a
The function block provides the following functions:
 Limit the upper and lower input signal value, for output signal "Modulating output
A" or "Modulating output B" respectively.
 Invert output signals "Modulating output A" or "Modulating output B".
 Convert the signal of a passive input signal to two active signals.
 Double the signal.
The output signals are provided in the range DC 0...10 V or as an internal, analog
signal (a).
9.3.1 Enable block
Assign an input to the function to enable this function.
Main menu > Commissioning > Extra configuration > Signal converter > Signal doubler-
inverter >
Operating line
Preselection external
Modulating output A
Modulating output B
9.3.2 Settings
You can set the output signal of the modulating outputs for each output as an upper
and lower value.
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Signal converter > Signal doubler-inverter >
Operating line
Value low A
Value high A
Positioning signal min A*
Positioning signal max A*
Inversion A
Value low B
Value high B
Positioning signal min B*
Positioning signal max B*
Inversion B
* The settings impact only signal Y, not the corresponding internal, analog output signal (a).
Switching and monitoring device RMS705B
Signal converter
Adjustable values / Comment
---, N.X1, N.X2, ...
---, N.Y1, N.Y2, ... /
enable modulating output.
---, N.Y1, N.Y2, ... /
enable modulating output.
Range
-50...+9999 %, °C
-50...+9999 %, °C
0...100 %
0...100 %
No, Yes
-50...+9999 %, °C
-50...+9999 %, °C
0...100 %
0...100 %
No, Yes
Factory setting
0, type-dependent.
50, type-dependent.
0 %
100 %
No
50, type-dependent.
100, type-dependent.
0 %
100 %
No
CE1P3124en
01.04.2010