Siemens Synco 700 RMZ785 Basic Documentation page 118

Fault messages
Settings
Function diagram
based on
1-speed motor
Siemens
Building Technologies
You can change the following texts ex-works texts in the RMS705B at the
password level.
No. Text
1318 [Mot 1] precom no checkb signal
1328 [Mot 2] precom no checkb signal
1338 [Mot 3] precom no checkb signal
1348 [Mot 4] precom no checkb signal
1358 [Mot 5] precom no checkb signal
1368 [Mot 6] precom no checkb signal
8.4.10 Motor operating state
The output motor operating state indicates if the motor is running at full speed.
Set the time the motor needs to reach full speed via the run-up time.
Main menu > Commissioning > Settings > ... or
Main menu > Settings > Aggregates > Motor > Motor 1...6 >
Operating line
Runup time
 You can configure the output motor operating state for all internal inputs.
 Use the motor operating state e.g. to send a checkback signal of the motor
state to the rotary step switch.
 The signal can have value "On" or "Off". It is "On" after the run-up time expires.
On
Off
TiRup
TiRup = Runup time
Switching and monitoring device RMS705B
Aggregates
Effect
Urgent message; must be
acknowledged and reset.
Urgent message; must be
acknowledged and reset.
Urgent message; must be
acknowledged and reset.
Urgent message; must be
acknowledged and reset.
Urgent message; must be
acknowledged and reset.
Urgent message; must be
acknowledged and reset.
Range
00.00...59.59 m.s
Factory setting
00.10 m.s
119 / 216
CE1P3124en
01.04.2010