Event Logger - Siemens Synco 700 RMZ785 Basic Documentation

Notes on the display
Trend signal not
available.
Remanent data
Purpose
Function overview
Siemens
Building Technologies
 The trend channels are displayed with their assigned text.
 The display immediately switches to the 24-hour view if a trend channel is
selected.
 The press-and-turn button allows you to navigate between the different views.
6.1.4 Troubleshooting
Trends no longer are recorded if a trend signal at the local inputs is no longer
available (e.g. due to a faulty sensor).
In this case, check the fault messages via:
Main menu > Faults > Faults current >
If the values are not available via bus, trends are no longer recorded.
Behavior after power failure or after exiting menu "Extra configuration" (restart
RMS705B):
 The values of the 8-hour and 8-minute views are deleted.
 The values of the 24-hour view and those of the last 6 days are retained.
6.2

Event logger

Use the event logger to log events and monitor their mandatory occurrence. Event
logging can be activated for max. 4 input variables, e.g. to monitor the minimum
event duration or regularity of an event (legionella monitoring).
 Event logger with 4 inputs.
 Logging of the last 10 events per logger with time and date stamp upon reaching
value "Limit value on" and Off.
 Save max. or min. value during event.
 Adjustable values for "Limit value on" and Off.
 Selectable fault message when below "Event cycle min".
 Selectable fault message when above "Event cycle max".
 Selectable fault message when below "Event duration min".
 Selectable fault message when above "Event duration max".
 A name can be assigned to each event logger input.
Switching and monitoring device RMS705B
Data acquisition
45 / 216
CE1P3124en
01.04.2010