YASKAWA E-V Series User Manual page 297

9 Appendix
9.1.2 Parameters
Parameter
Size
No.
2 Input Signal Selection 5
4th 3rd 2nd 1st
digit digit digit digit
n.
Pn511
Output Signal Inverse Set-
2
ting
4th 3rd 2nd 1st
digit digit digit digit
n.
Pn512
Pn517 2 Reserved (Do not change.)
Pn51B 4 Reserved (Do not change.)
Excessive Position Error
Pn51E 2
Warning Level
Excessive Position Error
Pn520 4
Alarm Level
Positioning Completed
Pn522 4
Width
9-18
Setting
Name
Range
0000 to FFFF
Homing Deceleration Switch Signal Mapping (/DEC)
0 Inputs the signal from CN1-7 input terminal.
1 Inputs the signal from CN1-3 input terminal.
2 to 6 Inputs the signal from CN1-8 input terminal.
7 Always active (fixed).
8 Not active (fixed).
9 Inputs the reversal signal from CN1-7 input terminal.
A Inputs the reversal signal from CN1-3 input terminal.
B to F Inputs the reversal signal from CN1-8 input terminal.
External Latch Signal Mapping (/EXT1)
0 to 6 Inputs the reversal signal from CN1-7 input terminal.
7 Always active (fixed).
8
Not active (fixed).
9 to F Inputs the signal from CN1-7 input terminal.
Reserved (Do not change.)
Reserved (Do not change.)
0000 to 0111
Output Signal Inversion for CN1-11 Terminal
0 Does not inverse outputs.
1 Inverses outputs.
Output Signal Inversion for CN1-10 Terminal
0 Does not inverse outputs.
1 Inverses outputs.
Output Signal Inversion for CN1-9 Terminal
0 Does not inverse outputs.
1 Inverses outputs.
Reserved (Do not change.)
–
–
10 to 100
1 to
1073741823
0 to
1073741824
Factory When
Units
Setting Enabled
−
6580 After restart
− 0000 After restart
– 0000 –
– 1000 –
1% 100 Immediately
1
refer- 5242880 Immediately
ence unit
1
refer- 7 Immediately
ence unit
(cont'd)
Reference
Classification
Section
Setup 3.3.1
Setup 3.3.2
– –
– –
Setup 8.2.1
5.1.4,
Setup
8.1.1
Setup 4.8.6