Command Types; Command Overview - Pepperl+Fuchs IC-KP-R2-V1 Manual

IC-KP-R2-V1
Commands
7.2

Command types

When using commands, a distinction is always made between the two command types single
mode and enhanced mode.
Single mode
The command is executed once. A response is issued immediately.
Enhanced mode
The command remains permanently active until it is interrupted by the user or by an error
message. A response is issued immediately.
The command remains active after the response is issued. Data is only transferred if read/write
tags change. Read/write tags are not read twice. If a read/write tag leaves the read range, the
status '5' is output.
7.3

Command overview

The commands in the list are described in detail on the following pages.
System commands
Command description
See "Version (VE):" on page 26
See "Change tag (CT):" on page 26
See "Quit (QU):" on page 28
See "Configure interface (CI):" on page 29
See "Configuration store (CS):" on page 29
See "Get state (GS):" on page 29
See "Reset (RS):" on page 29
See "Reset to defaults (RD):" on page 30
See "Set multiplexed mode (MM):" on page 30
See "Set trigger mode (TM):" on page 30
Standard read/write commands
Fixcode
Command description
See "Single read read only code (SF):" on page 31
See "Enhanced buffered read read only code (EF):" on page 31
Read data
Command description
See "Single read words (SR):" on page 31
See "Enhanced buffered read words (ER):" on page 31
Write data
Command description
See "Single write words (SW):" on page 31
See "Enhanced buffered write words (EW):" on page 32
24
Abbreviation
VE
CT
QU
CI
CS
GS
RS
RD
MM
TM
Abbreviation
SF
EF
Abbreviation
SR
ER
Abbreviation
SW
EW