Calibration and Testing
White Level Test
To perform the DBV-500 White Level Test,
proceed as follows:
1. Click the White Level Test Button (Figure 6-43
a).
Figure 6-43 White Level Test Button
Figure 6-43 White Level Test Button
2. Confirm that the "
appears (Figure 6-44).
3. Insert the KS-091 Reference Paper while refer-
ring to the instruction shown on the Screen.
Firmly close the Upper Guide until it "clicks"
into place, and ensure that both sides are tightly
closed and locked, then click the "
ton (Figure 6-44 a) to begin the White Level Test.
Figure 6-44 White Level Test Start Button
a
Figure 6-44 White Level Test Start Button
4. Once the White Level Test is completed, "
Paper Level Check Succeeded
message appears on the right column of the
Screen.
Click the "
"
Exit
end the White Level Test.
Figure 6-45 White Level Test Completion
a
Figure 6-45 White Level Test Completion
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
a
" Screen
WHITE LEVEL TEST
"
But-
Start
White
" (Figure 6-45 a)
Button (Figure 6-45 b) to
b
Performance Tests
This section provides Performance Testing instructions
for the DBV-500 Unit. There are two (2) Performance
Test methods:
•
Performance Test using a PC
•
Performance Test without a PC
Choose a Performance Test procedure by selecting
the one related to the particular circumstance
desired.
Performance Test Using a PC
To perform the DBV-500 Performance Tests using
a PC, proceed with the following steps. See Figure
6-1 and Figure 6-2 to confirm the necessary tools
and connections required.
Performance Test Preparation
To prepare the Performance Test, proceed as fol-
lows:
1. Remove electrical power from the DBV-500
Unit.
2. Set DIP SW1 #8 to ON (Figure 6-46).
Figure 6-46 DIP SW1 Setting
ON
1
2
3
Figure 6-46 DIP SW1 Setting
3. Apply electrical power to the DBV-500 Unit.
Confirm the LED flashes at a Green color rate
when the DBV-500 Unit is in Test Mode.
4. Connect the PC and the DBV-500 Unit using the
USB Cable.
5. Launch the "JCM Tool Suite Standard Edition"
Application and confirm that the Initial Screen
shown in Figure 6-47 appears.
6. Click the "Service Mode" Pull-down Menu, and
select "Performance Test" (Figure 6-47 a).
Figure 6-47 JCM Tool Suite Standard Edition
Initial Screen
a
Figure 6-47 JCM Tool Suite Standard Edition
Initial Screen
7. Confirm that the Performance Test Main Screen
appears (Figure 6-48).
© 2020 JAPAN CASH MACHINE CO., LTD.
6 - 9
Section 6
4
5
6
7
8