Step 6 Test For Read Rate - Microscan MS-860 User Manual

Step 6 — Test for Read Rate
If you don't have a test symbol, print out this page and use the symbol here for
testing.
Note: To the extent that the sweeping raster pattern extends above and below the
symbol, read rates will be diminished. To adjust raster pattern, see
page 8-3.
By EZ Button
Press and hold the EZ button until one beep along with
a single green flash is emitted from the reader and the
20% LED turns ON.
Note: This assumes the
mode of operation.
By ESP
After connecting to the reader, ESP will open in EZ Mode.
1. Click the Test button in EZ Mode to begin the read rate test.
2. Follow the instructions in Easy Setup Mode screen.
3. To end the Read Rate test, click the
Note: If the reader is in the default Continuous Read mode and not in read rate or
calibration, it will read and beep repeatedly as long as a readable symbol remains in the
read range and the read cycle configuration has not changed.
By Serial Commands
From a terminal window,
Send an <C> to begin the read rate test.
Send a <J> to end the read rate test.
MS-860 Industrial Raster Reader User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
EZ button is in its default
Stop button.
Quick Start
"Raster Setup"
20 mil Code 39 Test Symbol
"20 mil" refers to the width of the nar-
rowest bar (e.g., 7.5 mil = .0075" or
.1905 mm).
on
1-7