I/O Parameters - Microscan MS-860 User Manual

Chapter
10
I/O Parameters by ESP .............................................................................10-2
I/O Parameters by Serial Command..........................................................10-3
Symbol Data Output ..................................................................................10-4
Noread Message .......................................................................................10-7
Bad Symbol Message ...............................................................................10-8
No Symbol Message .................................................................................10-9
Output Indicators .....................................................................................10-10
Serial Verification ....................................................................................10-12
EZ Button ................................................................................................10-14
Input ........................................................................................................10-15
Output 1...................................................................................................10-16
Output 2...................................................................................................10-23
Output 3...................................................................................................10-24
Quality Output .........................................................................................10-25
Database Number Output .......................................................................10-26
Symbol Position Output ...........................................................................10-27
Read Duration Output .............................................................................10-30
This section includes instructions for setting up conditions for beeper and EZ Button
controls and for changing input/output of data messages and electrical transitions for
control of internal and external devices.
Note: The characters NULL, <, >, and
menus, not through ESP or serial commands.
Note: You can learn the current setting of any parameter by inserting a question mark
after the number, as in <K100?>. To see all "K" commands, send <K?>.
Note on Serial Commands: To preserve continuity with other Microscan products,
some serial configuration commands may include 0s (zeros) or 1s as placeholders. In
order for a these commands to be implemented, the placeholders must be included.
MS-860 Industrial Raster Reader User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

I/O Parameters

Chapter Contents
,
can only be entered through embedded
10-1