Table of Contents
Advertisement
a. Select User Access Manager > Portal Service Management > Device from the
navigation tree to open the portal device configuration page.
b. Click Add to open the page as shown in
c. Enter the device name NAS.
d. Enter the IP address of the router's interface connected to the host.
e. Enter the key, which must be the same as that configured on the router.
f. Set whether to enable IP address reallocation.
This example uses direct portal authentication, and therefore select No from the Reallocate
IP list.
g. Select whether to support server heartbeat and user heartbeat functions.
In this example, select Yes for both Support Server Heartbeat and Support User
Heartbeat.
h. Click OK.
Figure 123 Adding a portal device
4.
Associate the portal device with the IP address group:
a. As shown in
Figure
of device NAS to open the port group configuration page.
b. Click Add to open the page as shown in
c. Enter the port group name.
d. Select the configured IP address group.
The IP address used by the user to access the network must be within this IP address
group.
e. Use the default settings for other parameters.
f. Click OK.
Figure 124 Device list
Figure
124, click the icon in the Port Group Information Management column
Figure
361
123.
125.
Advertisement
Table of Contents
Troubleshooting
