H3C SR8800-F Configuration Manual page 347

Configuring the portal authentication server on IMC PLAT 3.20
In this example, the portal server runs on IMC PLAT 3.20-R2602P13 and IMC UAM 3.60-E6301.
1. Configure the portal authentication server:
a. Log in to IMC and click the Service tab.
b. Select Access Service > Portal Service Management > Server from the navigation tree
to open the portal server configuration page, as shown in
c. Configure the portal server parameters as needed.
This example uses the default values.
d. Click OK.
Figure 100 Portal authentication server configuration
2. Configure the IP address group:
a. Select Access Service > Portal Service Management > IP Group from the navigation
tree to open the portal IP address group configuration page.
b. Click Add to open the page as shown in
c. Enter the IP group name.
d. Enter the start IP address and end IP address of the IP group.
Make sure the host IP address (2.2.2.2) is in the IP group.
e. Select a service group.
This example uses the default group Ungrouped.
f. Select Normal from the Action list.
g. Click OK.
Figure 101 Adding an IP address group
3. Add a portal device:
Figure 101.
331
Figure 100.