Configuring The Pppoe Server; Pppoe Server Tasks At A Glance; Configuring A Pppoe Session - H3C SR8800-F Configuration Manual

Configuring the PPPoE server

PPPoE server tasks at a glance

Tasks at a glance
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Configuring a PPPoE session

Step
1. Enter system view.
2. Create a VT interface and
enter VT interface view.
3. Set PPP parameters.
4. Return to system view.
5. Enter interface view.
6. Enable the PPPoE server on
the interface and bind this
interface to the specified VT
interface.
7. (Optional.) Configure an
access concentrator (AC)
name for the PPPoE server.
8. (Optional.) Enable the
PPPoE server to support the
ppp-max-payload tag and
specify a range for the PPP
maximum payload.
9. (Optional.) Set a service
name for the PPPoE server
Configuring a PPPoE session
Setting the maximum number of PPPoE sessions
Limiting the PPPoE access rate
Configuring the NAS-Port-ID attribute
Enabling PPPoE users to come online despite the PPPoE-NAT444 collaboration failure
Setting the maximum number of PADI packets that the device can receive per second
Configuring PPPoE user blocking
Enabling PPPoE logging
Command
system-view
interface virtual-template
number
See "Configuring PPP."
quit
interface interface-type
interface-number
pppoe-server bind
virtual-template number
pppoe-server tag ac-name name
pppoe-server tag
ppp-max-payload [ minimum
minvalue maximum maxvalue ]
pppoe-server tag service-name
name
277
Remarks
N/A
N/A
If authentication is needed, use
the PPPoE server as the
authenticator.
N/A
N/A
By default, the PPPoE server is
disabled on the interface.
By default, the AC name for the
PPPoE server is the device
name.
PPPoE clients can choose a
PPPoE server according to the
AC name. The PPPoE client on
H3C devices do not support this
feature.
By default, The PPPoE server
does not support the
ppp-max-payload tag.
By default, the PPPoE server
does not have a service name.