Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Enter L2TP group view.
3.
Enable L2TP tunnel
authentication.
4.
Set the tunnel
authentication key.
Setting the Hello interval
To check the connectivity of a tunnel, the LAC and LNS periodically send each other Hello packets.
At receipt of a Hello packet, the LAC or LNS returns a response packet. If the LAC or LNS receives
no response packets from the peer within the Hello interval, it retransmits the Hello packet. If it
receives no response packets from the peer after transmitting the Hello packet eight times, it
considers the L2TP tunnel to be down.
To set the Hello interval:
Step
1.
Enter system view.
2.
Enter L2TP group view.
3.
Set the Hello interval.
Setting the DSCP value of L2TP packets
The DSCP field is the first 6 bits of the IP ToS byte. This field marks the priority of IP packets for
forwarding. This feature sets the DSCP value for the IP packet when L2TP encapsulates a PPP
frame into an IP packet.
To set the DSCP value of L2TP packets:
Step
1.
Enter system view.
2.
Enter L2TP group view.
3.
Set the DSCP value of
L2TP packets.
Setting the TSA ID of the LTS
To detect loops, the LTS compares the configured TSA ID with each TSA ID AVP in a received ICRQ
packet.
•
If a match is found, a loop exists. The LTS immediately tears down the session.
•
If no match is found, the LTS performs the following operations:
Encapsulates the configured TSA ID into a new TSA ID AVP.
Appends it to the packet.
Command
system-view
l2tp-group group-number [ mode
{ lac | lns } ]
tunnel authentication
tunnel password { cipher | simple }
string
Command
system-view
l2tp-group group-number [ mode
{ lac | lns } ]
tunnel timer hello hello-interval
Command
system-view
l2tp-group group-number [ mode
{ lac | lns } ]
ip dscp dscp-value
265
Remarks
N/A
N/A
By default, L2TP tunnel
authentication is enabled.
By default, no key is set.
Remarks
N/A
N/A
The default setting is 60 seconds.
Remarks
N/A
N/A
The default setting is 0.
Advertisement
Table of Contents
Troubleshooting
