H3C SR8800-F Configuration Manual page 257

Specifying a PPP address pool on the server interface
Step
1. Enter system view.
2. Configure a PPP address pool.
3. (Optional.) Enable new IP
address assignment.
4. (Optional.) Configure a
gateway address for the PPP
address pool.
5. (Optional.) Configure a PPP
address pool route.
6. Enter interface view.
7. Configure the interface to
assign an IP address from the
configured PPP address pool
to the peer.
8. Configure an IP address for the
interface.
Specifying a DHCP address pool on the server interface
Step
1. Enter system view.
2. Configure DHCP.
3. Enter interface view.
Command
system-view
ip pool pool-name
start-ip-address [ end-ip-address ]
[ group group-name ]
ip pool pool-name
allocate-new-ip enable
ip pool pool-name gateway
ip-address [ vpn-instance
vpn-instance-name ]
ppp ip-pool route ip-address
{ mask-length | mask }
[ vpn-instance
vpn-instance-name ]
interface interface-type
interface-number
remote address pool pool-name
ip address ip-address
Command
system-view
•
If the server acts as a DHCP
server, perform the following
tasks:
Configure the DHCP
server.
Configure a DHCP
address pool on the
server.
•
If the server acts as a DHCP
relay agent, perform the
following tasks:
Configure the DHCP
relay agent on the server.
Configure a DHCP
address pool on the
remote DHCP server.
Enable the DHCP relay
agent to record relay
entries.
Configure a DHCP relay
address pool.
interface interface-type
interface-number
241
Remarks
N/A
By default, no PPP address
pool is configured.
By default, new IP address
assignment is disabled.
By default, the PPP address
pool is not configured with a
gateway address.
By default, no PPP address
pool route exists.
The destination network of the
PPP address pool route must
include the PPP address pool.
N/A
By default, an interface does not
assign an IP address to the
peer.
By default, no IP address is
configured on an interface.
Remarks
N/A
For information see
"Configuring the DHCP
and "Configuring the DHCP
relay agent."
N/A
server"