Enabling Pppoe Users To Come Online Despite The Pppoe-Nat444 Collaboration Failure - H3C SR8800-F Configuration Manual

Step
3. Configure the content of the
NAS-Port-ID attribute.
4. Configure the NAS-Port-ID
attribute to include the BAS
information automatically.
5. Configure the PPPoE server
to trust the access line ID in
received packets.
6. Configure the format that is
used to parse the circuit-id.
7. Configure the transmission
format for the circuit-id.
8. Configure the transmission
format for the remote-id.
Enabling PPPoE users to come online despite the
PPPoE-NAT444 collaboration failure
If a card that supports NAT444 collaboration fails, the PPPoE-NAT444 collaboration fails. You can
use this command to enable IPv4 PPPoE users to come online despite the collaboration failure. For
more information about NAT444, see NAT in Layer 3—IP Services Configuration Guide.
Enabling IPv4 PPPoE users to come online despite the PPPoE-NAT444 collaboration failure
Step
1. Enter system view.
2. Create a VT interface and
enter VT interface view.
3. Enable IPv4 PPPoE users to
come online despite the
PPPoE-NAT444
collaboration failure.
Enabling IPv6 PPPoE users to come online despite the PPPoE-NAT444 collaboration failure
Step
1. Enter system view.
2. Create a VT interface and
enter VT interface view.
3. Enable IPv6 PPPoE users to
come online despite the
PPPoE-NAT444
collaboration failure.
Command
pppoe-server access-line-id
content { all [ separator ] |
circuit-id | remote-id }
pppoe-server access-line-id
bas-info [ cn-163 ]
pppoe-server access-line-id
trust
pppoe-server access-line-id
circuit-id parse-mode
{ cn-telecom | tr-101 }
pppoe-server access-line-id
circuit-id trans-format { ascii |
hex }
pppoe-server access-line-id
remote-id trans-format { ascii |
hex }
Command
system-view
interface virtual-template
number
ppp ip nat-fail online
Command
system-view
interface virtual-template
number
ppp ipv6 nat-fail online
280
Remarks
By default, the NAS-Port-ID
attribute contains only the
circuit-id.
By default, the NAS-Port-ID
attribute does not include the BAS
information automatically.
By default, the PPPoE server
does not trust the access line ID
in received packets.
The default mode is TR-101.
The default format is a string of
characters.
The default format is a string of
characters.
Remarks
N/A
N/A
By default, IPv4 PPPoE users
cannot come online if the
PPPoE-NAT444 collaboration
fails.
Remarks
N/A
N/A
By default, IPv6 PPPoE users
cannot come online if the
PPPoE-NAT444 collaboration
fails.